Farm King BW200, Operator And Parts Manual

Page: 37 / 82

Operation - 200 Bale Wrapper
35
Drive Chain Adjustment
Figure 19
Two chain transmissions are used in this bale
wrapping machine. After wrapping the first ten
bales, the tensioning of the drive chains needs to
be adjusted.
Remove the chain cover (Item 1). Loosen the four
M12 nuts (Item 2). Turn the M12 screw in the chain
tightening mechanism (Item 3) so that the chain
has a 20 mm slack after tightening
[Figure 19] .
Tighten the four M12 screws (Item 2). Install the
chain cover
[Figure 19] .
IMPORTANT
Check the tightening and the chain condition
periodically after wrapping every 120 bales.
3
1
FINISHING WORK
After the work is complete, disconnect the
revolution counter and secure the revolution
sensor against humidity.
Before storing the wrapping machine for a longer
period, place the impulse sensor in a dry storage
room.
Make sure that there are no bystanders, especially
children, in the coupling area.
Place the wrapping machine for storage on a hard,
flat and level ground.
Switch off the tractor engine, remove the ignition
key and engage the tractor parking brake.
Unplug the electrical power supply.
Disconnect the hydraulic system.
Lower the main chassis support. Disconnect the
hitch-ring from the transport hitch. Make sure that
the machine will not move accidentally.
Support the draw bar by using the support stand.
Disconnect the machine draw bar from the tractor
hitch.
WARNING
It is forbidden to disconnect the wrapping
machine from the tractor when there is a bale on
the rotary table.
Clean the machine and inspect its condition
paying special attention to the quality of the paint
coat. Touch up paint as required.
Protect the rubber elements, such as hydraulic
lines, against direct sunlight.
2