Farm King BW200, Operator And Parts Manual

Page: 43 / 82

Maintenance - 200 Bale Wrapper
41
TROUBLESHOOTING
WARNING
Instructions are necessary before operating or servicing equipment. Read and understand the Operator
And Parts Manual and safety signs (decals) on equipment. Follow warnings and instructions in the
manuals when making repairs, adjustments or servicing. Check for correct function after adjustments,
repairs or service. Untrained operators and failure to follow instructions can cause injury or death.
NOTE: If a problem is encountered that is difficult to solve, even after having read through this
troubleshooting section, please call your local Farm King dealer. Before you call, please have this
Operator And Parts Manual and the serial number of your machine at hand.
PROBLEM CAUSE CORRECTION
Wrapping machine hydraulic
actuators work slowly or do
not work at all. Not enough oil in the tractor
hydraulic system.
Pressure in the tractor hydraulic
system too low.
Wrong diameter setting of the
external diameter lever.
Damaged actuator.
Check the oil level in the
tractor. Top up oil.
Check the tractor hydraulic
system pressure.
Turn on the pump drive.
Replace the actuator
The wrapping machine works
too slowly. Not enough oil in the tractor
hydraulic system. Check the oil level in the
tractor. Top up oil.
Oil leaks from the control unit. Worn seal rings. Replace the seal rings
on the hydraulic control unit.
Too wide or too narrow
overlapping of film edges
during wrapping. Improper installation of the
chain wheel. Replace with a proper chain
wheel.
The cut film is not held in the
cutter unit. The rubber clamp holding
the cut film is not adjusted
properly. Adjust the film pressure
element.
Problems with bale unloading. Rotary table lock does not
operate. Lock the table..