Farm King BW200, Operator And Parts Manual

Page: 29 / 82

Operation - 200 Bale Wrapper
27
Install a new roll of film (Item 1) to the feeder
assembly as follows
[Figure 9] :
• Move the metal rollers (Item 2) out of the way
and secure using the hook attached to the
wrapping assembly.
• Turn the crank (Item 3) to loosen the upper pin.
• Set the height of the lower pin (Item 4) in
position appropriate for the film roll width (500
mm or 750 mm).
• Place the film roll (Item 1) on the cone of the
lower pin. Make sure the internal sticky side of
the film faces the bale axis.
• Turn the crank (Item 3) to tighten the upper pin
onto the roll.
• Tighten the nut on the crank screw to secure
the roll.
• Move the metal rollers (Item 2) back into
position.
Pull the film through the rollers as indicated on
the pictogram placed on the gear cover
[Figure 8].
Pull out the end of the film so that it may be easily
handled in the machine.
Wrapping Film Size
Figure 10
The wrapping machine is pre-set to use 750 mm
film. The chain wheel (Item 1, 2) must be replaced
to use 500 mm film
[Figure 10] .
Replace the chain wheel as follows:
• Remove the washers and nuts from the side
cover. Remove the side cover to expose the
chain transmission.
• Loosen the M12 screw on the chain tightening
mechanism.
• Remove the chain from the Z27 chain wheel
(Item 1) installed on the main shaft and remove
the split pin securing the wheel.
• Remove the Z27 chain wheel from the shaft (by
using an appropriate tool).
• Replace with the Z17 chain wheel (Item 2).
• Secure the Z17 chain wheel repeating the above
procedure in the reverse order.
• Store the unused chain wheel on the storage
shaft (Item 3).
2 3
3 1