Farm King Allied Binary Series, Operator And Parts Manual

Page: 49 / 100

Operation - Binary Series
47
Adjusting Skid Shoe Height
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s position:
• Always park on a flat level surface.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
WARNING
AVOID INJURY OR DEATH
Securely block up the implement before
working underneath.
Park the tractor and implement on a flat level
surface.
Fully raise the snowblower.
Stop the engine and leave the operator’s position.
(See “Leaving The Operator’s Position” in the
Operation section). Make sure the PTO driveline and
all rotating components have come to a complete
stop before leaving the operator’s position.
Place blocking under the snowblower. Position
blocking away from skid shoes, allowing access to
skid shoe mounting bolts and nuts.
Enter the operator’s position. (See “Entering The
Operator’s Position” in the Operation section).
Start the engine.
Lower the snowblower onto the blocking.
Stop the engine and leave the operator’s position.
Skid Shoe Settings:
Decrease Working Depth - Lower skid shoes.
Increase Working Depth - Raise skid shoes.
Figure 35
Remove bolts and nuts (Item 1) on the skid shoe
(Item 2)
[Figure 35] . Raise or lower the skid shoe to
the desired depth setting. Reinstall bolts and nuts
to secure the skid shoe in position.
Note: Skid shoes must be level from front to back.
Left and right skid shoes must be set at the
same working depth.
Repeat procedure on opposite skid shoe.
Verify both skid shoes are set at the same depth
setting.
WARNING
Snowblower should not be operated with skids
completely removed as damage to housing
may result.
2
1