Farm King Allied Binary Series, Operator And Parts Manual

Page: 38 / 100

Assembly - Binary Series
36
740 Models
Figure 26
Align the right and left hitch tubes (Item 1) [Figure
26] with the welded sleeves on the main body.
Slide the tubes into the sleeves as shown, with
the end brackets facing up. Each tube has two
mounting holes, to be used depending on the
tractor.
Attach each tube using one 3/4” x 4-1/4” pin and
hair pin clip.
Bolt the top hitch tube (Item 2) [Figure 26] to the
top of the main frame.
Attach the top hitch tube using the same mounting
hole as the left and right hitch tubes. Use one 3/4”
x 4” hex bolt, flat washer, and lock nut.
Align the left and right hitch arms (Item 3) [Figure
26] with the inside brackets on the hitch tubes.
Attach each hitch arm with a 7/8” x 5” hex bolt and
lock nut.
Figure 27
Attach the top brackets of the left and right hitch
arms (Item 1) by bolting a link pin bushing (Item
2) between the top brackets with a 3/4” x 4” bolt
(Item 3)
[Figure 27] , flat washer, and lock nut. Use
the bottom front holes on the brackets.
Attach the hitch top bar (Item 4) between the top
brackets with one 3/4” x 4” bolt (Item 5)
[Figure 27]
, flat washer, and lock nut. Use the rear holes on
the brackets.
Tighten all hardware.
Attach a Category 1 top link pin (Item 6) and
bushing (Item 7)
[Figure 27] to the top front holes
of the top brackets.
The Category 1 pin is used for a standard three-
point hitch only. The bushing in the lower hole is
used for the Quick Hitch.
2
1
3
3
1
2
7
1
3
6
5
4