Farm King Allied Binary Series, Operator And Parts Manual

Page: 37 / 100

Assembly - Binary Series
35
Three-Point Hitch
50”, 60”, 66” Models
Figure 23
Align the right and left hitch tubes (Item 1) [Figure
23] with the welded sleeves on the main body. Slide
the tubes into the sleeves as shown, with the end
brackets facing in. Each tube has four mounting
holes, to be used depending on the tractor.
Attach each tube using one 3/4” x 3-1/4” pin (Item
2) and hair pin clip (Item 3)
[Figure 23] .
Figure 24
Align the left and right hitch arms (Item 1) with
the outside of the end brackets on the hitch tubes.
Attach each hitch arm with a Category 1 lift arm pin
(Item 2)
[Figure 24] , washer, and nut
The linch pin / lift arm pin should face out. Do not
tighten any hardware until assembly is complete.
Figure 25
Attach the top brackets of the hitch arms by bolting
a 1” x 2-1/4” spacer (Item 1) between the top
brackets with a 3/4” x 4” bolt (Item 2)
[Figure 25]
and lock nut. Use the bottom front holes on the
brackets.
Attach the top hitch tube (Item 3) between the
brackets with a 3/4” x 4” bolt (Item 4)
[Figure 25]
and lock nut. Use the bottom rear holes on the
brackets.
Bolt the opposite end of the top hitch tube (Item 3)
to the brackets on the main frame with a 3/4” x 4”
hex bolt (Item 5)
[Figure 25]
, two 3/4” flat washers,
and a 3/4” lock nut. Use the same hole position as
the other hitch tubes.
Tighten all hardware.
Attach a Category 1 top link pin (Item 6) [Figure 25]
to the top holes of the top brackets.
The Category 1 pin is used for a standard three-
point hitch only. The bushing in the lower hole is
used for the Quick Hitch.
1
2
3
4
5
3
6
1
2
3
1
2
2
1