RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
3-45
Inspecting the Card Lamination Module
While unpacking your Lamination Module, inspect the carton to ensure that no damage has
occurred during shipping. (
Note:
Make sure that all supplied accessories are included with
your unit.)
Your new Lamination Module is packaged in a standard HDP600 Card Printer/Encoder
carton. (
Note:
It is recommended that you save the packaging in the event that you need to
transport the Card Printer/Encoder/Laminator at a future date.)
Unpacking the Card Lamination Module
The following items are included with your new Lamination Module:
•
Card Lamination Module
•
Power Supply with a Power Cord (for the Card Lamination Module)
•
Installation
CD
•
Warranty
Card
•
Registration
Card
Choosing a proper Location
Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build-up.
•
Use the Printer's dimensions (10.75 H x 35.5 W x 13 D) as a guideline for the minimum
clearances to the unit. (
Note:
Allow for adequate clearance above the unit to
accommodate the height of the unit with its covers open.)
•
Do not install the unit near heat sources, such as, radiators or air ducts.
•
Do not install the unit in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.
Preventing Moisture Condensation
If the unit is brought directly from a cold to a warm location or if the unit is placed in a very
damp room, moisture may condense inside the unit. (
Note:
If this condition occurs, print
quality may not be at its optimum level.)
Follow this guideline:
•
Leave the unit turned OFF in a warm, dry room for several hours before using it. (
Note:
This will allow the moisture to evaporate.)
