RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
5-50
Restoring the Factory Settings for Ethernet
There may be times when you are unable to use the current configuration of the Ethernet
interface. (
Note:
This could be because you have lost the password for your Printer or you
just cannot get it to work properly.)
•
Restore default settings:
The Printer has switches on the back which will restore the
factory default settings to the Printer.
•
Dipswitch indicators:
For the DTC400,
ON
means a Dipswitch is down and
OFF
means a Dipswitch is up. For the HDP600,
ON
means a Dipswitch is to the left and
OFF
means a Dipswitch is to the right.
•
Lost Password or Printer Problems:
There may be times when you are unable to use
the current configuration of the Ethernet interface. (
Note:
This could be because you
have lost the password for your Printer or you just cannot get it to work properly.)
Enter this mode by following this procedure.
Step
Procedure
1
Remove power from the Printer.
2
a. Place the switch furthest from the LEDs in the
ON
position (Dipswitch 1
ON
).
b. Place the switch closest to the LEDs in the
OFF
position (Dipswitch 2
OFF
).
3
Reconnect power to the Printer.
4
After 30 seconds, remove power, restore both switches to their normal
positions (which is
OFF
) and then restore power.
Restoring the Default Settings
The DTC400 and HDP600 have switches on the back which will restore the factory default
settings to the Printer.
•
Dipswitch indicators:
For the DTC400,
ON
means a Dipswitch is down and
OFF
means a Dipswitch is up. For the HDP600,
ON
means a Dipswitch is to the left and
OFF
means a Dipswitch is to the right.
To enter this mode on the DTC400 and HDP600, follow the next procedure.
