RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
11-8
Preparing to Adjust the Print Offset, Transfer TOF
and Transfer EOF
Step Procedure
1
Before starting the alignment procedures, you must first establish a baseline
from which to start the adjustments.
Before adjusting the Print Offset, TOF and EOF, the Print and Transfer Film
Sensors should be calibrated.
•
Ensure that the Film is loaded into the Printer and that no Film marks are
resting under Sensors.
•
Close the Lid and all other covers.
•
From the Sensor Calibration menu, select Calib Film Sensors. The Printer
will then calibrate the Sensors automatically.
2 Select
MENU
,
Setup
Printer
,
Print Settings
.
3 Select
the
Offset button
.
4
Set baseline for CR-80 to -15 and CR-100 to -30 and press the
Select
button.
5 Select
Transfer
TOF
.
6
Set to +40 and press the
Select
button.
7 Select
the
Transfer
EOF
button.
8
Set to ZERO and press the
Select
button.
