Fargo HDP100, User Manual

Page: 49 / 121

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
8
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
LAM LIFT ERROR See the next column. If this problem persists, call for
technical assistance.
CHECK LAM
MATERIAL Lamination material is
low. See Resolving Check Lamination
Material Error .
LAM MEMORY
ERROR See the next column. If this problem persists, call for
technical assistance.
MAG ENCODING The magnetic stripe was
not encoded properly. See Resolving a No Magnetic
Strip Present Error .
Magnetics: The Magnetic Encoder
was properly installed. No action required.
MAG ENCODER
PAUSED The head arm assembly
has been opened during
Magnetic Encoding,
causing this operation to
halt.
Press RESUME to retry or
CANCEL to abort. See
Magnetic
Encoding Errors .
MAG ENCODER
STARTUP ERROR A problem has been
detected in the MAG
encoding section of the
Printer during start-up. If this problem persists, call for
technical assistance. See
Magnetic Encoding Errors .
Continued on the next page