RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
6
Reviewing HDP
100 Series Card Printer
–
Sequence of Operations (continued)
Step Process
23
The Film Drives turn ON to rewind the printed portion of the Film into position at
the heated Transfer Roller using the Lamination Film Alignment Sensor.
24
If the heater is not at the required temperature yet, the job will pause.
25
Stepper engages to move the card to a position directly under the hot Roller. The
Card Feed/Position Sensor determines card edge and number of steps to position
card. All stop.
26
The Headlift Motor turns ON to lower the hot Roller and will stop when the Headlift
Sensor is activated. All stop.
27
The Stepper and Film Drive engage to laminate the printed Film onto the card.
They will turn off after a given number of steps based on the position given by the
card Sensor. All stop. (Note: The Film Encoder is active during this step.)
28
The Headlift Motor turns ON to raise the hot Roller, stopping when the Headlift
Sensor is activated.
29
The Film Drive and Stepper turn ON for a given number of clicks based on Film
Encoder, until the film is released.
30
The Stepper turns ON to move the card into Flipper Module to flip the card to the
opposite side. After flipping the card is transported back to the Card Feed/Position
Sensor to repeat Steps 9 to 14. Upon completion of print all print cycles the card
is transported to the Output Hopper (based on steps from a known from Flipper
Card Position Sensor). All stop.
31
The Heater is maintained at a set temperature by the RTD when the Printer is ON.
The cooling fan is ON when the Printhead is ON or hot.
