: 8VHU 0DQXDO
Picture 29 - IPv6 Static IP network mode
9.9.2
VPN
Virtual Private Network (VPN) is a technology to allow device to create a tunneling connection to a server
and becomes part of the server’s network. The network transmission of the device may be routed through the
VPN server.
For some users, especially enterprise users, a VPN connection might be required to be established
before activate a line registration. The device supports two VPN modes, Layer 2 Transportation Protocol
(L2TP) and OpenVPN.
The VPN connection must be configured and started (or stopped) from the device web portal.
L2TP
NOTICE! The device only supports non-encrypted basic authentication and non-encrypted data
tunneling. For users who need data encryption, please use OpenVPN instead.
To establish a L2TP connection, users should log in to the device web portal, open webpage
[
Network
] >> [
VPN
]. In VPN Mode, check the “Enable VPN” option and select “L2TP”, then fill in the L2TP
server address, Authentication Username, and Authentication Password in the L2TP section. Press “Apply”
then the device will try to connect to the L2TP server.
When the VPN connection established, the VPN IP Address should be displayed in the VPN status.
There may be the delay of the connection establishment. User may need to refresh the page to update the
status.
Once the VPN is configured, the device will try to connect with the VPN automatically when the device
boots up every time until user disable it. Sometimes, if the VPN connection does not establish immediately,
user may try to reboot the device and check if VPN connection established after reboot.
OpenVPN
To establish an OpenVPN connection, user should get the following authentication and configuration files
from the OpenVPN hosting provider and name them as the following,
OpenVPN Configuration file:
client.ovpn
CA Root Certification:
ca.crt
Client Certification:
client.crt
Client Key:
client.key
User then upload these files to the device in the web page [
Network
] >> [
VPN
], select OpenVPN Files.
Then user should check “Enable VPN” and select “OpenVPN” in VPN Mode and click “Apply” to enable
OpenVPN connection. Same as L2TP connection, the connection will be established every time when system
rebooted until user disable it manually.
Summary of Contents for LINKVIL W712
Page 1: ...8VHU 0DQXDO User Manual W712 Software Version 2 12 0 Release Date 2023 2 3...
Page 17: ...8VHU 0DQXDO Picture 8 Channel configuration Picture 9 Digital channel parameters...
Page 22: ...8VHU 0DQXDO Picture 15 Setting voice prompt...
Page 27: ...8VHU 0DQXDO For example extension 1 dials extension 0...