Fanvil H3W, Administration And User Manual

Page: 27 / 80

28
Picture 12 - Landing page
Users must correctly enter the user name and password to log in to the web page. The default user name and
password are "admin". For the specific details of the operation page, please refer to page
11 Web
configuration.
The device relies on IP network connection to provide service. Unlike traditional phone system based on a
circuit switched wire technology, IP devices are connected to each other over the network and exchange data
in packet basis based on the devices’ IP address.
NOTICE! If user saw a ‘WAN Disconnected’ icon flashing in the middle of screen, it means the
network cable was not correctly connected to the device’s network port. Please check the cable is
connected correctly to the device and to the network switch, router, or modem.
The device supports three types of networks
，
IPv4/IPv6/IPv4&IPv6
There are three common IP configuration modes about IPv4

Dynamic Host Configuration Protocol (DHCP) – This is the automatic configuration mode by getting
network configurations from a DHCP server. Users don’t need to configure any parameters manually. All
configuration parameters will be getting from DHCP server and applied to the device. This is
recommended for the most users.

Static IP Configuration – This option allows user to configure each IP parameters manually, including IP
Address, Subnet Mask, Default Gateway, and DNS servers. This is usually used in a technical
environment of network users.

PPPoE - This option is often used by users who connect the device to a broadband modem or router. To
establish a PPPoE connection, user should configure username and password provided by the service
provider.
The device is default configured in DHCP mode.
There are three common IP configuration modes about IPv6

DHCP - This is the automatic configuration mode by getting network configurations from a DHCP server.
Users need not to configure any parameters manually. All configuration parameters will be getting from
DHCP server and applied to the device. This is recommended for most users.

Static IP configuration - this option allows users to manually configure each IP parameter, including IP
address, mask, gateway, and primary and secondary domains. This usually applies to some