GL-35DSR Getting Started
1.7 Before Use
1.7.1 Hard
Drive
Assembly
1. Unlock the switch at the bottom of the case and lift the front panel upward and away from
the housing to remove it.
2. Install the hard drives as illustrated below with the top of the drives, where the label is
located, facing each other. Push the drives lightly into the SATA interface and then lock the
front panel.
Note
Be careful not to damage any components, and do not force the drives into the SATA interface to
hard. If they not easily slide into it and fit, make sure the drives have been installed correctly. The
top of the drives, where the label is located, should face each other.
Important
It is not possible to start with only one HDD and then adding a second HDD at a later point. In this
way you have to re-initializing the system which will affect a loss of all existing data!
EN
5/37