6.
The white O-ring featured on the back side of
the front door should be visually inspected prior
to each dive. If there is any debris present,
gently wipe the area with a soft microfiber cloth
in order to cleanse it.
7.
The white O-ring featured on the back side of
the front door shouldn’t be removed unless it’s
damaged.
8.
If the white O-ring is removed and replaced,
note that it is not symmetrical and should be
inserted with its rounded edge
(into its seat) and its pointed edge
outward (image #9). Improper installation of
the white O-ring may affect housing
functionality and watertight seal.
WHEN INSTALLING THE RX100 III CAMERA INS
If using the housing to accommodate the RX100 III camera
should be installed on the Select / Rotary Wheel
inside. This C-shaped washer enables an easier and smoother use of this control with the RX100 III
camera. The C-shaped washer should only be installed once following this procedure:
1.
Open the back side of the housing.
2.
Identify the Select / Rotary Wheel control
the interior back side of the housing.
3.
Gently remove the black rubber
installed at the end of this control by
pinching it and then gently pulling
using your fingers. Pull it away f
plastic 2-pointed seat (image #
4.
Remove the plastic C-shaped washer
its bag and use small needle nose pliers
securely hold it without damaging it (image
#11).
5.
Using one hand, press the Select / Rotary
Wheel control from the exterior side of the
housing, so the metal shaft sticks out from
FRX100 VA R Housing Instruction Manual
17
featured on the back side of
should be visually inspected prior
to each dive. If there is any debris present,
gently wipe the area with a soft microfiber cloth
ring featured on the back side of
the front door shouldn’t be removed unless it’s
ring is removed and replaced,
note that it is not symmetrical and should be
rounded edge facing inward
pointed edge facing
(image #9). Improper installation of
fect housing
functionality and watertight seal.
RX100 III CAMERA INSIDE THE HOUSING
If using the housing to accommodate the RX100 III camera a small plastic C-shaped washer
/ Rotary Wheel control of the housing prior to installing
enables an easier and smoother use of this control with the RX100 III
should only be installed once following this procedure:
of the housing.
Identify the Select / Rotary Wheel control on
housing.
emove the black rubber disc
installed at the end of this control by
pinching it and then gently pulling it out
Pull it away from its black
(image #10).
shaped washer out of
small needle nose pliers to
without damaging it (image
the Select / Rotary
terior side of the
housing, so the metal shaft sticks out from
Instruction Manual 20200225
shaped washer (included)
to installing the camera
enables an easier and smoother use of this control with the RX100 III
should only be installed once following this procedure:
Image #10
Image #9
