Identification of System Parts
(Housin
* With a Vacuum Valve installed on the housing’s dedicated M16 port
Charging the Unit
1.
Turn the unit on using the power switch featured on the Signal Board.
2.
The LED Indicator will start flashing blue:
a.
Slow flashing (approx. 1 flash per second) indicates a
charged battery.
b.
Rapid flashing (approx. 4 flashes per second) indicates low
battery.
3.
To charge the unit, connect it to a USB charger using a standard
Micro-USB cable (not included). Note that it is best using
android phone charger unit for this purpose.
4.
Connect the micro-USB end of the cable to the
the Signal Board (image #22). Connect the other end of the cable to
a USB port or USB charger.
5.
The unit should start charging and the
flashing green.
6.
Make sure to keep the unit turned
7.
When charging is complete, the
8.
Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
battery power. If the unit is left turned on, the battery will
9.
During charging, keep the charger away from highly flammable materials or products and never
leave the charger unattended when in use
10.
Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
Vacuum Valve
Protective Cap
FRX100 VA R Housing Instruction Manual
25
(Housing Back Door Exterior)*
* With a Vacuum Valve installed on the housing’s dedicated M16 port
Turn the unit on using the power switch featured on the Signal Board.
The LED Indicator will start flashing blue:
Slow flashing (approx. 1 flash per second) indicates a
flashing (approx. 4 flashes per second) indicates low
To charge the unit, connect it to a USB charger using a standard
USB cable (not included). Note that it is best using an
for this purpose.
SB end of the cable to the Micro-USB port on
Connect the other end of the cable to
The unit should start charging and the LED Indicator should start
Make sure to keep the unit turned on during charging.
When charging is complete, the LED Indicator stops flashing and remains green
Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
battery power. If the unit is left turned on, the battery will drain within a few days.
keep the charger away from highly flammable materials or products and never
leave the charger unattended when in use.
Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
Image #
Vacuum
Release Tip
Vacuum Valve
Instruction Manual 20200225
stops flashing and remains green.
Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
drain within a few days.
keep the charger away from highly flammable materials or products and never
Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
Image #22
