d.
Cleaning the O-ring is a simple matter of wiping it with a da
foreign matter. Be careful the cloth you use does not leave any of its own material
behind as this can also affect the effe
e.
Apply a slight layer of Fantasea S
lubrication required on the O
friction, so it does not twist or become dislodged. More
and in some cases might interfere with the watertight seal of the housing.
f.
Reinstall the O-ring and then reinstall the Vacuum Valve using the wrench.
g.
Confirm that the housing watertight seal hasn’t been interfered using t
dive check prior to diving with the housing again.
3.
Never soak or wash the interior of the housing with water. This will caus
to all Hybrid Vacuum Safety System
Vacuum Valve Removal
1.
In case of removing the Vacuum Valve for whatever
reason, follow the steps below:
a.
Remove the Vacuum Valve from its port using
the wrench. Fit the wrench around the edges
of the Vacuum Valve base and turn it
counterclockwise until the valve has been
completely unscrewed.
b.
Install the M16 Cap (previously removed)
the Vacuum Valve port by screwing it all the
way in (image #29).
Important Notices
1.
Once the
installed on the port
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been affected during the replacement
2.
The Vacuum Valve port was designed to accommodate the Vacuum Valve
only and any other compo
FRX100 VA R Housing Instruction Manual
31
ring is a simple matter of wiping it with a damp, soft cloth to remove the
Be careful the cloth you use does not leave any of its own material
behind as this can also affect the effectiveness of the seal.
Fantasea Silicone Grease on the O-ring. Note that the amount of
lubrication required on the O-ring is only enough to allow it to slip into place without
friction, so it does not twist or become dislodged. More grease is not necessarily better,
and in some cases might interfere with the watertight seal of the housing.
ring and then reinstall the Vacuum Valve using the wrench.
Confirm that the housing watertight seal hasn’t been interfered using t
dive check prior to diving with the housing again.
Never soak or wash the interior of the housing with water. This will cause irreparable damage
to all Hybrid Vacuum Safety System electronic components!
emoving the Vacuum Valve for whatever
reason, follow the steps below:
Remove the Vacuum Valve from its port using
the wrench. Fit the wrench around the edges
of the Vacuum Valve base and turn it
counterclockwise until the valve has been
ed.
(previously removed) on
the Vacuum Valve port by screwing it all the
Once the Vacuum Valve has been removed and an M16 port
installed on the port, it important to carry out the first dive with the housing
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been affected during the replacement
The Vacuum Valve port was designed to accommodate the Vacuum Valve
only and any other components should not be installed on this port.
Image #29
Instruction Manual 20200225
mp, soft cloth to remove the
Be careful the cloth you use does not leave any of its own material
that the amount of
ring is only enough to allow it to slip into place without
grease is not necessarily better,
and in some cases might interfere with the watertight seal of the housing.
ring and then reinstall the Vacuum Valve using the wrench.
Confirm that the housing watertight seal hasn’t been interfered using the vacuum pre-
e irreparable damage
M16 port cap has been
the first dive with the housing
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been affected during the replacement.
The Vacuum Valve port was designed to accommodate the Vacuum Valve
nents should not be installed on this port.
