fann MACS II, User Manual, Page: 55 / 165

MACS II User Manual
101796668 Revision E 46
4. Press. – Same as above but for pressure.
5. Oper. Mode – This pull down list are motions previously defined on the
Machine Settings screen. Selecting one of the defined motion steps
automatically fills in the Speed section of that step.
The Speed section cannot be edited in the Profile editor.
All changes for motion have to set through the Motion tab
on the Machine Settings screen.
6. Speed – This section only provides information to the user as to what each
Oper. Mode does.
By right clicking, on the step number on the left side of the sequence, it is possible
to add, delete, copy, and paste individual steps in the profile.
The Stop Condition determines whether to stop the test when the sequence is
complete or when the test attains a specified SGS target. Specify the Target SGS if
the second option is chosen.
Click OK to save any changes and close this screen. Click Cancel to exit this screen
without saving any changes.
5.5. Calibration Menu
The Calibration Menu manages various calibration tasks for the MACS II system.
This menu contains the following options.

Zero Drive

Calibrate Pressure

Calibrate SGS

Test Repeatability
5.5.1. Zero Drive
Click Calibration > Zero Drive to initialize the stepper drive to a known position.
This operation is independent of other functions in the program. When the process
begins, a dialog box displays.
Figure 5-9 Zero Drive Adjusting Drive Mechanism Message