Falcon Professional+ FXP 90 Dual Fuel, User Manual

Page: 40 / 48

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
36
ArtNo.322-0002 Oven bottom element access
A
B B
Fig.9-11
4.3 To Replace the Oven Catalytic Converter
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Undo the 2 screws holding the catalytic filter cover in
place (Fig.9-7) and remove.
Pull out the catalytic assembly.
Replace the catalyst and fit in reverse, making sure that
the cover fits over the ends of the thermostat phials.
4.4 To Remove an Oven Inner Back Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Open the oven door. For the right-hand side unscrew
the 4 thermostat phial fixing screws.
Remove the fixings that secure the inner back to the
oven rear (Fig.9-8) . Lift the removable panels away.
Reassemble in reverse order. Make sure that the
retaining fixings are fully tightened.
4.5 Replacing an Oven Fan
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull the cooker forward to access the cover boxes at the
rear of the cooker.
Remove the inner back panel (see 4.4).
Hold the fan blades and undo the centre nut (Left-hand
thread), brass washers, fan blade and circlip
(Fig.9-9)
.
Undo the screws that retain the fan and remove it from
the cavity rear.
Fit the replacement and reassemble the parts in reverse
order.
Check that the oven operates satisfactorily.
4.6 Replacing an Oven Fan Element
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the inner back panel (see 4.4).
Remove the screws that secure the element within the
oven and carefully lift the element away
(Fig.9-10)
.
Disconnect the leads and connect to the replacement
element and reassemble the parts in reverse order.
4.7 To Replace the Top and Bottom Elements
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Bottom Element
Pull the cooker forward to allow access to the cover
boxes at the rear. Remove the fixings that secure the
cover and lift it clear.
Remove the 2 screws ‘A’ and allow the plate to drop
down. Remove the 2 screws ‘B’, and then lower the
upper plate and remove it through the slot in the cooker
back (Fig.9-11) .
Undo the terminal connections, noting their positions.
Remove the element fixings and withdraw the element.
Replace the element and reassemble the parts in
reverse order.
ArtNo.281-0148
- USA Oven Fan
ArtNo281-0148 USA Oven Fan
Fig.9-10
ArtNo.281-0149 - Fan oven inner
Fig.9-9
Fig.9-8
Catalytic
assembly
Filter cover
Fig.9-7