24
Checkpoint
Okay
Not OK Not okay, solution:
Remarks:
Mechanical
Check if all bolts and nuts are firmly tightened and in
place.
Tighten bolts and nuts and replace them if necessary.
Check the scissor parts for signs of wear and tear, cracks
and deformation.
Put the lift out of use immediately, have the broken
parts repaired/replaced immediately by a professional
mechanic, only use original Falco-parts to replace broken
parts.
Check the drive-on ramps for signs of wear and tear,
cracks and deformation.
Put the lift out of use immediately , have the broken
parts repaired/replaced immediately by a professional
mechanic, only use original Falco-parts to replace broken
parts.
Check the base frame for signs of wear and tear, cracks
and deformation.
Put the lift out of use immediately, contact your Falco-
retailer.
Check the rubber pads for signs of wear and tear,
cracks and deformation.
Replace the rubber pads, onl use original Falco parts.
Check the concrete floor for signs of wear and tear,
cracks and deformation.
Put the lift out of us immediately,
- Have a professional mechanic assess the situation.
- Replace the entire floor if necessary, refer to chapter 3
of this user manual for the demands which the concrete
floor has to meet.
Checkpoint
Okay
Not OK Not okay, solution:
Remarks:
Hydraulic
Check the oil level in the oil tank.
Top up oil level with Falco CH46V Hydraulic oil.
Thoroughly check the entire hydraulic system for
leakages and signs of wear and tear.
Put the lift out of use immediately,
-
Repair leakages.
-
Replace leaking parts, only use original
Falco parts to replace broken parts.
Check if the oil is not polluted or aged.
Drain oil and replace with Falco CH46V Hydraulic oil.
Check if all gaskets are still good.
Replace worn/defect gaskets.
Check if there are no changes in the noise level of the
motor when it’s working.
Put the lift out of use immediately and have a
professional mechanic check/repair the motor.
Standard periodical maintenance protocol VL30F230B
