Fagor AD-125, Installation, Use And Maintenance Instructions

Page: 77 / 148

77
6.3 Prolonged periods of inactivity
If the machine is going to be inactive or out of service for a long period of time (holidays, temporary
closure…), the following should be observed:
•
Drain the machine completely, including the boiler.
•
Clean the machine thoroughly.
•
Leave the hood of the machine open.
•
Close the water mains inlet tap.
•
Switch off the mains power supply.
•
The appliance must not be in left in environments with temperatures less than 5 ºC.
7 FAULTS, ALARMS AND BREAKDOWNS
A list of possible causes and solutions in the event of anomalies or operating errors is given below. In the
event of doubt, or if you are unable to resolve the problem, please contact the technical service.
PRECAUCIÓN
PRÉCAUTION
WARNING
VORSICHT
PRECAUZIONE
TENSIÓN PELIGROSA
TENSION DANGEREUSE
HAZARDOUS VOLTAGE
GEFÄHRLICHE SPANNUNG
TENSIONE PERICOLOSA
THIS APPLIANCE MAY ONLY BE REPAIRED BY AN AUTHORISED AND QUALIFIED
TECHNICAL SUPPORT SERVICE.
THE MANUFACTURER MAY NOT BE HELD LIABLE FOR ANY PROPERTY DAMAGE OR
PERSONAL INJURY RESULTING FROM THE INCORRECT INSTALLATION, USE,
MAINTENANCE OR REPAIR, OR CAUSED BY FAILURE TO COMPLY WITH THE
STANDARDS AND INSTRUCTIONS PROVIDED.
FAULT POSSIBLE CAUSE ACTION
Machine does
not come on.
The appliance does not receive mains
power. Check whether the magneto-thermal circuit breaker
or the differential switch has tripped.
Blown fuses.
Call the technical service to have it replaced and the
cause analysed.
Water does not
enter the
machine.
Interruption to the supply of water or the
intake water valve is closed. Check whether there is water in the main system and
open the shut-off valve.
Rinse nozzles blocked.
Clean the nozzles. If there is a build-up of lime on the
arm, contact the technical service to have the
appliance cleaned.
Solenoid valve filter blocked. Call the technical service to have it cleaned.
Faulty solenoid valve. Call the technical service to replace it.
Rinse pump faulty Call the technical service to replace it.
Pressure switch broken. Call the technical service to replace it.
Incorrect wash.
There is no detergent. Fill the rinse aid container.
Insufficient detergent. Call the technical service to reset the dispenser.
Wash distributors obstructed. Clean distributors thoroughly.
Dirty filters. Clean the filters thoroughly.
Presence of foam.
Inadequate detergent. Change detergent.
Too much rinse aid. Call the technical service to reset
the dispenser.
Temperature in tank less than 50 ºC /
122 ºF. Faulty thermostat or incorrect setting. Contact the
technical service.
Cycle length too short.
Select a longer cycle in accordance with the dirt on
the dishes.
Water too dirty. Drain the wash tub and fill with clean water.