1,35 m (53,1 in)
pic. 3
pic. 4
pic. 5
Dissuasore antiterrorismo oleodinamico a scomparsa
0.0
0.0
!
1-2 cm
English
INSERTING THE BOLLARD INTO ITS SEAT
Unscrew the six M12 screws that fix the cover plate and remove it
by means of M16 supplied screws.
Remove the four x M18 screws and replace them with the four lifting rings allowing for the bollards to be hoisted.
Position the bollard as indicated in the picture, and use a level to make sure it is in axis.
POSSIBLE FUNCTIONING TEST (non mandatory for the installation)
Talos M50 is factory-tested in all normal conditions of functioning,
before being sent out to customer.
Nevertheless, to allow that a few running tests to assess functioning are
carried out before the installation, it is possible to access the inner
terminal board with the electrical connections by removing the hatch
cover: undo the two lateral screws of the cover and pull out the junction
box with its connector.
Open the connector and carry out the electrical connections as
illustrated in pic. 16 page 12.
ATTENTION: Once the first running test is finished, fit
back the junction box and close back the hatch.
junction box
with connector
Anti-terrorism retractable oil-hydraulic bollard
SECTIONAL VIEW
INTERNAL SIDE TO PROTECT
EXTERNAL SIDE
possible
submersed
pump
finished
road
level
Ø 50 mm (Ø1,9 in)
tube for the
electric cables
to go through
Elpro S50-T1 or Elpro S50-T2
or Elpro S50-T3
5
M16
M16
M18
M18
M12
