Ø 275
Ø 10,8 in
1.000 mm
39,37 in
1.045 mm
41,14 in
620 mm
24,4 in
780 mm
30,7 in
630 mm
24,8 in
730 mm
28,7 in
1.665 mm
65,55 in
pic. 1
470 x 470 mm
16,9 x16,9 in
English
Anti-terrorism retractable oil-hydraulic bollard
GENERAL DESCRIPTION
Security bollard fitted with a post, that retracts completely flat with the road level, and an incorporated oil-hydraulic motor-pump.
Suitable for heavy duty applications being certified and tested in compliance with:
- ASTM F2656-15 C750
- PAS 68:2013 V/7500 (N3)/80
- IWA 14-1:2013 V/7200 [N3C]/80
The bollard is designed and constructed to be able to stop vehicles weighing 7.500 kg, running at a speed of 80 km/h and to
absorb at least 1.872.000 Joules of energy, in compliance with the ASTM F2656-15, PAS 68:2013 and IWA 14-1:2013 standards.
This bollard is designed for the protection of special areas, such as: military bases, airports, embassies, consulates, banks, prisons,
etc. and all those areas requiring a high level of security and perimeter protection.
The bollards is fitted with a post (cylinder) rising 1.000 mm from ground level, diameter 275 mm, thickness 20 mm.
The post of the bollard (when in fully raised position) remains 50 cm (constraint) inside the enclosure and is supported by two
reinforcement plates, the thickness of each is 15 and 30 mm respectively.
The post is made of S355K2H steel, the surface is cataphoresis treated and coated by polyester powder; the post of the bollard is
well visible in any climate conditions, being fitted with an approved, back-reflecting band sticker. The post head is completed with
a rubber edge providing protection in case of accidental impacts with pedestrians, etc. and 12 LEDs flashing.
The foundation casing is made of treated steel, hot dip galvanized, while the structure of the inner assembly of the bollard is cold
dip galavanized.
It is fitted with two magnetic limit switches: one for the post in raised position and one for the post in lowered position.
All the inner electrical connections (oil-hydraulic motor-pump, limit switches, LEDs and possible accessories) are factory pre-wired
in a watertight junction box fitted with a quick disconnection connector for the power supply cable.
The protection grade of the connector fitted to the junction box is IP 66.
Available, on request, even IP 67 and explosion-proof.
The oil-hydraulic drive unit is made up of two pumps, each operated by a 230 Vac electric motor. Protection grade IP 67.
They are located in the upper part of the foundation enclosure, outside of the post, and are easy to be accessed once the
rectangular cover plate has been removed.
High pressure tubes (300 bars) connect the oil-hydraulic drive unit to the actuator.
ELPRO S50 is a printed circuit control board powered with 230 Vac voltage, external to the bollard and housed in a plastic box
made of polycarbonate. Connections between the bollard and the control board must be made by using a multipole cable type
FG 7OR 12x1,5 mm² up to 20 m maximum; beyond this distance, cable section must be adequate, according to the rules of good
installation praxis.
Post cover with rubber edge
Steel retractable post
Ø 275 mm (Ø 10,8 in) thickness 20 mm (0,78 in)
Casing for concrete embedding
complete with inner assembly inclu-
ding actuator, oil-hydraulic drive unit
and terminal board for the electrical
connections
LEDs with flashing light
Reflecting sticker
3
