Usermanual 4TrackTrigger TP2.5 18 / 18
Control element
Function
FX3 ASSIGN Button
If the effect assign button FX3 is pressed, the corresponding deck will be allocated
to FX slot 3.
FX4 ASSIGN Button
If the effect assign button FX4 is pressed, the corresponding deck will be allocated
to FX slot 4.
Deck section
Control element
Function
SHIFT + COPY Button
The desired headphone signal can be activated with the Monitor button.
Extensions
All the controls in Traktor Pro may be assigned to new functions, which are accessed in the
Preferences/Controller-Manager.
Particulars are given in the Traktor Pro manual.
Since some shift functions of the controller remain unassigned, the following extensions are
suggested:
•
FX- potentiometers
•
Some buttons in master clock section
As long as Leds are allocated to buttons, they may be controlled by the same Midi- commands as
those for the buttons.
For information about the numbers of the particular Midi- commands, first check the included list of
the corresponding functions in the included setup.
Especially, the two large grey buttons in each deck (on either side of the red Play buttons) offer
themselves for allocation of often-required functions. By using the Modifier function (Shift + Size-
button and Display in Loop-Recorder-Section), it is easy to allocate individual alternative functions
with these buttons in the Setup V03. By doing this, the “Modifier Condition” on M4 = 1…7 in the
section “Mapping Details”, must be set in the Traktor preferences for the newly added own
allocations. The value 1...7 corresponds to the adjusted value in the device (Shift + Size button and
display in the Loop-Recorder section). Thus you obtain 7 alternative allocation possibilities for the
two buttons. If the value is set to 0, the above described standard functions (Loop active & Beatjump)
are used. In order to have the individual allocations in connection with the Modifier function
immediately available after plugging in the device, the Modifier starting value can be saved in the
device. To this end, the value is determined via Shift + Size button in the Loop-Recorder section,
then calls up the system mode at the device and subsequently withdraws from it (each by
simultaneously pressing the View Browse-Encoder).
Summary of Contents for 4TrackTrigger
Page 1: ...Usermanual 4TrackTrigger...
