17
8. With the expendable tool threaded into the
Rivnut, insert it into one of the holes making
sure that it fits in far enough to flush the collar
of the Rivnut to fender panel. For an exceptional
installation coat the knurls of the Rivnut with
Loctite.
7. Fully dill out the holes with the 17/32” drill bit.
(Figure 23)
9. Place the 9/16” box end wrench on the body
of the expendable tool and the 9/16” socket and
ratchet on the bolt head on the back side of the
tool. (Figure 24)
10. Tighten the bolt into the Rivnut until it becomes
snug in the fender panel. DO NOT OVER TIGHTEN
CAUSING THE INSERT TO SPIN!
11. Repeat steps 6-10 to drill the remaining Rivnut
hole locations marked on the vehicle.
Figure 23
Figure 24
13. Using a 7/32” Allen wrench, install the 3/8”-
16 button head bolts and rubber bonded washers
using Loctite. (Figure 25)
12. With assistance, reinstall the upper ViCowl
using steps 1-3 of the ViCowl installation section.
Figure 25
14. Using an extension and 9/16” socket/ratchet,
fully tighten the 3/8” yellow zinc hex screw used to
tighten the arm to the bracket.
