1. Apply the provided rubber edge trim (61727) to the outer profile of the four (4) provided fender flares
(21453-21456) by starting at one end and working it across to the opposite end. Then use a razor blade
to trim off the excess. Figure 1-2
Figure 1
2. Using a 3/16” Allen wrench, remove the three (3) stainless steel button head cap screws per base
fender installed previously in preparation for the fender flare hardware.
3. Using a 1/2” open end wrench, install the provided driver’s side front fender flare (21453) with three
(3) of the provided 5/16”x1” grade 8 screws, flat washers, and lock washers. Figure 3-4
Figure 2
Installation |
Fender Flares
