![background image](http://html1.mh-extra.com/html/faac/t-mode-tm-45-e/t-mode-tm-45-e_manual_3117238007.webp)
X 1
X 1
ENGLISH
7
FIND THE PUSH-BUTTON CONTROLLING THE UP MOVEMENT AND HOLD IT PRESSED UNTIL
THE MOTOR ROTATES IN BOTH DIRECTIONS (END OF SET-UP).
Fig. 8
4.2.2 AUTOMATIC SET-UP FOR ROLLER SHUTTERS, WITH MANUAL SETTING OF THE DOWN TRAVEL STOP
(For roller shutters with opening mechanical stops only)
WHEN THE SEMI-AUTOMATIC SET-UP IS PERFORMED, THE MOTOR SETS IN THE ROLLER SHUTTER MODE.
If the mechanical obstacle detection sensor has not been installed, the semi-automatic set-up can be performed
and the down travel stop can be set manually. Up mechanical stops MUST BE AVAILABLE to set the up travel stop.
1)
Press and hold down the button
controlling the rolling shutter rise.
2)The rolling shutter rises till meeting the up mechanical stop, then it lowers.
(Do not release the button)
3) Release the button where the down travel stop is to be set.
4) Press the up and down buttons at the same time till the motor makes 1 short movement in both directions.
5) By controlling the rolling shutter rise and lowering, check the correct setting of the two travel stops.
6) If the travel stops have not been set correctly, make a reset and repeat the set-up procedure.
FIND THE BUTTON CONTROLLING THE UP MOVEMENT AND HOLD IT PRESSED WITHOUT
RELEASING IT TILL REACHING THE WISHED POSITION OF DOWN TRAVEL STOP. PRESS THE
UP AND DOWN BUTTONS AT THE SAME TIME TO CONFIRM THE POSITION TILL THE MOTOR
MAKES THE INDICATED MOVEMENTS.
DOWN
TRAVEL STOP
IF THE MOTOR DOES NOT REACH ONE OF THE TWO STOPS RATHER STOPS EARLIER, CHECK POSSIBLE FRICTIONS ON THE ROLLING
SHUTTER AND REMOVE THEM; OTHERWISE, PERFORM THE MANUAL SET-UP.
Fig. 9
Summary of Contents for T-MODE TM 45 E
Page 1: ...T MODE TM 45 E TM 58 E...