5
a
b
a
b
a
b
b
a
c
a
xx°(3)
xx°(2)
xx°(1)
ENGLISH
By means of table 1
(see white or grey boxes)
choose the
fixing hole on the rear bracket and install the fork (Fig. 7
re.
a
) by assembling it with the special pin supplied (Fig. 7
re.
b
).
2.
Install the encoder on the rear bracket by correctly engaging
it on the pin then fix it with the screw and nut supplied (Fig.
8 re.
a
b
c
).
Slightly press the protection cover on the rear bracket to
install it (Fig. 9).
Assemble the operator and the rear bracket by means of
the pin and nut supplied (Fig. 10 re.
a
-
b
).
3.
4.
5.
Fig. 7
Fig. 9
3.3 INSTALLATION OF OPERATORS
Check the perfect level then weld the rear fitting to the
pillar or fix it by means of suitable screws, dowels / threaded
inserts. Observe the dimensions stated in Tab.1
(never cut
the rear fitting; moreover it must be installed with the word
"UP" facing up as shown in figure 6 re.
a
).
1.
Fig. 8
Fig. 10
Fig. 11
Screw one-half of the thread of the front articulated joint on
the operator rod and tighten the nut (Fig. 11 re.
a
).
Unlock the operator according chapter 4.
If no external mechanical stop
point at closure is present,
you may use the stop point inside the operator. Therefore
remove the rod completely up to its internal stop point.
If an external mechanical stop
point at closure is present,
remove the rod completely and then insert it 5 mm.
6.
7.
8.
9.
INSTALL THE BRACKET
WITH THE WORD “UP”
FACING UP
HOLE FOR
ENCODER
CABLE
ROUTING
Fig. 6
DO NOT TIGHTEN
THE NUT TOO
MUCH
www.metalines.com
