25
If you press push-button P1 again, all 5
LEDs from A to E will light.
(Make sure that the gate is closed and
operators locked)
12.4.7 Simple learning
If you press push-button P2 for 1 second,
the MASTER-B leaf and the SLAVE-B
leaf will begin to move together until
the opening mechanical stop-point is
reached. The 5 LEDs flash during this
stage. After learning has been
completed, the 5 LEDs remain lighted
steadily.
P1
P2
t
Press push-button P1 again to exit (all
LEDs OFF). Give a pulse with the radio
control to close the gate.
Press push-button P1 again and
LED
E
will light together with LED
2
.
12.4.6 Speed
Press push-button P2, for a choice
of 4 different speeds
E1
low
E2
medium low (default)
E3
medium high
E4
high
P1
P2
t
P1
P2
t
ÜÜ
If you press push-button P1 after setting
the speed, all 5 LEDs from A to E will
light.
(Make sure that the gate is closed and
operators locked)
12.4.8 Complete learning
If you press push-button P2 for more
than 3 seconds, leaf 1 begins to move.
You can command the following
functions with subsequent pulses from
P2 (or by key-operated push button or
radiocontrol):
1st pulse - leaf 1 opening deceleration
starts.
Allow leaf 1 to reach its stop-point and
when it is still, leaf 2 opening movement
begins.
(1)
2nd pulse - leaf 2 opening deceleration
starts.
Allow leaf 2 to reach its stop-point and
when it is still, leaf 2 closing movement
begins.
(1)
3rd pulse - leaf 2 closing deceleration
starts and when the leaf has reached
its stop-point, the leaf 1 closing
movement begins.
4th pulse - leaf 1 closing deceleration
starts - allow leaf 1 to reach its stop-
point.
The 5 LEDs flash during this stage.
Note (1):
if you have no opening
mechanical stop-points, give the stop
command at the required point with a
further pulse from P2.
Press push-button P1 again to exit when
learning has finished (all LEDs OFF).
P1
P2
t
P1
P2
t
P1
P2
t
P1
P2
t
P1
P2
t
