#
#
#
Complete this step prior to programming the gate movements. This will
dictate how your gate will react during programming.
If you do not use a backup battery and lose power or if you must
disconnect all power during programming to reset your control board,
you MUST start at this step before programming movements or
operating your gate, all parameters return to default.
Entering programming mode
1. Make the necessary power connections and check the LED lights to be sure the appropriate
lights are lit.
2. The display should show
3. Press and hold down
P2
until the display shows parameter A
with the corresponding number that is currently default or pre-
viously programmed.
4. Press
P1
to change the number variable of the parameter,
USE
THE CHART ON THE NEXT PAGE AS A GUIDE.
5. To move to the next parameter, Press
P2
.
6. When 60 seconds have elapsed without any button being
pressed the control unit automatically exits the programming
mode. To exit manually, Press
P2
to scroll through all the pa-
rameters until the display shows
Important Dip Switch Setting
Verify the 4 dipswitches to the left of the display LED are as follows:
1. OFF
2. OFF
3. ON
4. ON
!
Summary of Contents for Estate Swing e-sU 2200 series
Page 1: ...Manufactured by...