'
1. The Estate Swing E-SC 1600 comes with 1) 24V transformer. The transformer sup-
plied has 2 screw terminals to connect to. You may locate the transformer up to
1000’
away from the control board using wire ratings as specified below
.
2. Insert the two wires from the transformer into the two VAC terminals on the control
board (CN1). The wires are not polarized, there is no positive or negative.
Do not
splice the power cable wire.
Never run 110VAC power directly to the Estate Swing. This will destroy the Es-
tate Swing control board.
Never connect the power wire with the transformer plugged in. Contact between the
two lead wires, even for a second, will destroy the transformer.
3. Plug the
transformer
into a 110 V AC
outlet.
4. The transformer is not weather proof
and must be kept in a covered area.
Plug
covers are available from your dealer,
contact 1-800-640-GATE for a dealer in
your area.
5. Two 12V DC batteries may be run in
series as backup to the 24V transformer
power. Running two 12V batteries in series
creates a 24V system,
you cannot run them
in parallel
(see diagram to the left)
6. The power light located below the
+24V and –24V output terminals will be
on if the power is connected properly. If
the light is off then power through the
transformer is not functioning properly and
either the unit has no power or is on bat-
tery backup.
The light stays off during bat-
tery backup.
12V
12V
•
0-99 Feet - Use 16 Gauge, 2 Conductor Stranded Direct Burial Wire
•
100-299 Feet - Use 14 Gauge, 2 Conductor Stranded Direct Burial Wire
•
300-599 Feet - Use 12 Gauge, 2 Conductor Stranded Direct Burial Wire
•
600-1000 Feet - Use 10 Gauge, 2 Conductor Stranded Direct Burial Wire
Summary of Contents for Estate Swing e-sU 2200 series
Page 1: ...Manufactured by...
