![background image](http://html1.mh-extra.com/html/faac/e124/e124_manual_3113221025.webp)
23
ENGLISH
8.3 MEMORY STORAGE OF THE LC/RC RADIO CONTROLS
A maximum of 256 codes can be saved, split
between OPEN A and OPEN B.
use LC/RC remote controls only with a 433 Mhz receiver
module.
Press push-button R (SW) or (SW2) to save respectively total
opening (OPEN A)or partial opening (OPEN B). The relevant
LED starts to flash slowly for 5 sec.
Release the push-button.
Within these 5 sec., press the appropriate push-button on
the LC/RC remote control.
The LED lights steadily for second, indicating memory
storage executed, and then resumes flashing for another
5 sec., during which another radio control can be memory
stored.
When the 5 sec. have elapsed, the LED goes OFF indicating
the end of the procedure.
To add other radio controls, repeat the operation at point .
8.3.1 REMOTE SAVING OF LC/RC RADIO CONTROLS
Other radio controls can be remotely stored with the LC/RC
radio controls, i.e. without directly intervening on the board, by
using a previously stored radio control.
Obtain a radio control already stored on one of the 2
channels (OPEN A or OPEN B )
Press and hold down push-buttons P and P2 simultaneously
until both LEDs flash slowly for 5 sec.
Within 5 sec. press the push-button of the radio control
that had been memory stored to enable learning on the
selected channel.
The LED on the board relating to the channel being learned
flashes for 5 sec., within which time the code of another
radio control must be transmitted.
The LED lights steadily for 2 seconds, indicating memory
storage executed, and then resumes flashing for 5 sec.,
during which other radio controls can be memory stored,
and then goes OFF
8.4 RADIO CONTROLS DELETION PROCEDURE
To delete
ALL
the input codes of the radio controls just press
push-button R (SW) and R2 (SW2) for 0 sec.
The 2 LEDs DL6 and DL7 flash quickly for the following
0 sec.
Both LEDs light steadily for 2 sec and then go OFF (deletion
effected).
Release both push-buttons.
This operation is NOT reversible. All codes of
radio controls stored as OPEN A and OPEN B will
be deleted.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
9
CONNECTION TO EMERGENCY BATTERIES (OPTIONAL)
The emergency batteries will activate the automated system
also in the event of a power cut.
The batteries (
Lead 12V- 4 Ah/90 x70 x 108 mm
)
are normally charged by a battery charger
built into the board and start operating when
a mains power cut occurs.
The emergency batteries can be inserted inside the container
of the control board, laying them against a specific support.
Remove the container cover with a screwdriver.
.
Insert the support as shown in the figure below.
2.
Insert the batteries as shown in the figure below.
3.
Fig. 28
Fig. 29
Fig. 30