FAAC E045, Manual

Page: 24 / 44

E045 24 732786 - Rev.C
ENGLISH
5.3 BUS-2EASY DEVICE INSTALLATION
You can add BUS-2EASY devices to the system at any time, proceeding as follows:
1. Cut off the electrical power to the board.
2. Install and set the
BUS-2EASY accessories according to the instructions of the devices.
3. Connect the BUS-2EASY devices according to the instructions of Chapter ELECTRICAL CONNECTIONS .
4. Power up the board.
5. Complete the procedure for
BUS-2EASY device entry.
5.3.1 BUS-2EASY DEVICE ENTRY
1. Access BASIC programming and scroll through the functions up until
bu
. When
F
is released, the
display will show the BUS-2EASY devices status (see the figure) .
2. Perform the entry: simultaneously press and hold
+
and
-
for at least 5 sec (during this time, the
display will blink).
3.
Y
will appear as a confirmation of entry completion.
4. Release the
+
and
-
buttons. The status of the BUS-2EASY devices will be displayed.
If no BUS device has ever been entered in the board, the display will read
no
.
Fig. Visualising the BUS-2EASY status in the function
bu
: each segment of the display shows one type
of device.
Encoder 1 : ON = correctly connected
and entered
Encoder 2 :
ON = correctly connected and
entered
BUS Status : always ON
OPEN photocell :
ON = entered and engaged
Opening photocells :
ON = entered and engaged
Closing photocells :
ON = entered and engaged
Opening photocells
and Closing photocells
:
ON = entered and engaged