A1400 AIR RDT
63
532119 04 - Rev. C
Tr
ansla
tion of the original instruc
tions
ENGLISH
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
--
PRELIMINARY CHECKS PRIOR TO COMMISSIONING
!
Before commissioning the system, regular and friction-less door
movement must be ascertained.
Manually check the leaves slide smoothly, with mains power supply,
emergency battery and motors disconnected.
If battery charge is insufficient, automation operation is prevented;
the door remains OPEN (ERROR status 10) until the emergency battery
charging cycle is completed. Only SETUP may be performed in any
case despite the battery being down.
It is recommended to charge the emergency batteries before
commissioning, to avoid waiting time for the charging cycle after
performing SETUP.
The battery must be charged exclusively by using the electronics
module for A1400 AIR RDT
13.1 SYSTEM POWER SUPPLY AND SETUP
1. Close the leaves or partially open them with mains and battery
power supply disconnected.
2. Connect the 2 motors and M1 motor encoder.
3. Connect the 230 V
~
mains power supply.
The board turns on. The display reads in sequence:
-
bo
bo
(Bootloader)
-
FW version (2 digits separated by a point)
-
L0
L0
blinking = system requires setup
The door performs a SLOW OPENING and remains OPEN in error (
13
13
on the display).
!
If the door CLOSES instead of opening, it is necessary to immediately
disconnect power supply, invert connections of Auxiliary_motor then
power back on.
If the door does NOT move, it is necessary to immediately disconnect
power supply, check motor connections then restore power supply.
4. Connect the battery.
5. Enter programming and perform the required modifications (
11
and
12
).
!
IMPORTANT TO PROGRAM:
- number of leaves
Ln
Ln
- partial opening adjustment
PO
PO
- Both E1-E2 Emergencies are not active
- configuration of safety detectors
Id
Id
,
Ed
Ed
The setup CANNOT be performed in NIGHT-TIME and MANUAL func-
tion.
13. COMMISSIONING
6. Command SETUP
0.0
RESET/SETUP
DL2
+
-
F
J
L0...L1...
L0...L1...L2
L2......
5 s
SW1
SETUP/RESET
The door performs SETUP and the ongoing phases are displayed:
L0
L0
...
L1
L1
...
L2
L2
.
Upon completing SETUP, the display shows automation status (see
14
).
!
During SETUP the safety detectors are ignored. To prevent any
hindrance to motion, keep at a distance and prevent anyone from
going near the system.
CHECKS FOLLOWING SETUP
Check correct operation of the following:
-
safety detectors inputs (S1-S4)
-
devices connected to inputs
(I1-I4)
-
emergency (E1-E2)
-
configurable outputs (O1-O2)
-
any connected control devices.
SAVING THE CONFIGURATION
At the end of functional tests, download the full configuration of
the system.
Use the DOWNLOAD procedure shown on
(
78
).
