13
ENGLISH
ENGLISH
The carriages enable height adjustment of the leaves.
Adjustment procedure:
•Slightly loosen the two hexagon head screws in fig. 18 ref.
.
•Turn the screw (fig.18 ref.
) clockwise to raise the leaves or
anti-clockwise to lower them.
•Re-tighten the screws.
Procedure for carriages where height adjustment cannot be
accessed:
Fig. 18
8.
INSTALLATION OF THE LEAVES
•Fit the leaf attachment profile (accessory fig.17 ref.
) on the
top of the leaf, using adequate screws.
•Secure the leaf on the relevant carriages, using the supplied
plates (fig.17 ref.
) and screws (fig. 17 ref.
).
•Position the carriages of the automated system as shown in
the following figures:
Figure 4: right opening
Figure 5: left opening
Figure 6: four leaves
•Tighten the screws of the carriages
Fig. 17
7.
INSTALLATION OF BOTTOM SLIDING BLOCKS
The bottom sliding blocks are designed for securing to the wall
(or stationary leaf) or to the floor.
Securing on the wall (or on stationary leaf):
•Assemble the sliding blocks, considering in mind the
dimensions in figs.14 and 16.
For the free-standing version, we advise you to use the sliding
block in fig. 16.
•Secure the sliding blocks as shown in fig. 15 ref.
.
Securing on the floor
•Secure the sliding block directly to the floor, as shown in fig.
15. ref.
, using adequate expansion plugs and screws.
8.2
Adjustment of the counter roller
The carriages are supplied with a counter wheel. Adjustment
procedure below:
•Loosen the two hexagon head screws (fig. 18 ref
and
).
•Slide the screw fig. 18 ref.
inside the slot, so that, while the
carriage is moving, the counter wheel slides on the profile
without jamming.
Check if the wheel can be locked without stopping the
carriage.
9.
ADJUSTMENT OF THE TRAVEL STOP LIMITS
Adjustment of the opening mechanical stops
The 940 SMT series doors are supplied with the opening
mechanical stops mounted on the sliding profile.
Make sure that, when the leaves are being opened, the
sliding carriages simultaneously reach the opening travel limit
mechanical stops.
If adjustments are necessary, proceed as follows:
•Take the leave into opening position.
•Loosen the two hexagon head screws as shown in figures 21
and 22 ref.
.
•Take the mechanical stop toward the carriage until the two
parts come into contact.
•Tighten the two hexagon head screws.
Adjustment of the closing mechanical stop.
The 940 SMT series doors are supplied with the carriages
reaching their trave stop limit on the closing edge (fig.23). If
the door centre has to be adjusted, proceed as follows:
8.1
Leaf adjustment
Fig. 16
3
0
1
2
1
8
14,5
35
30 - 42
Fig. 14
Fig. 15
3
0
1
2
1
8
7
14,5
35
61 -75
Fig. 19
Fig. 20
•Loosen the three screws as shown in fig. 19 ref.
and adjust
the leaf.
•Loosen the two screws as shown in fig. 20 ref.
(without
uncoupling the belt from its support) and adjust the leaf.
