38
37
746 E R
25
732099 - Rev.D
J7
N
L
PE
N
L
PE
N
L
J2
Tr
ansla
tion of the original instruc
tions
ENGLISH
RADIO RECEIVER/DECODER BOARD
!
Always disconnect power from the board before installing/removing the
receiver/decoder board.
Install a FAAC 5-pin radio receiver board or a decoder board that is compatible,
in terms of frequency and coding technology, with the FAAC radio controls
that are used:
- a single-channel system only enables the OPEN A radio command
- a two-channel system enables the OPEN A and OPEN B/CLOSE radio com-
mands (according to the programmed operating logic).
Insert the radio receiver or the decoder board into the quick insertion
connector
J2
. The connector is polarised, therefore make sure that
it is inserted the correct way round (
37
).
EARTHING THE GEARMOTOR
F
Cut the power to the system before making the connections.
1. Crimp the earthing conductor of the mains power cable and a similar
cable, approximately 20 cm long, onto the cable lug (provided in
the hardware/accessories) (
38
).
2. Fasten the cable lug to the earth connection of the gearmotor using
the nuts and washer provided with the hardware/accessories.
3. Connect the free end of the cable to the earth terminal on the board.
POWER CABLE
F
Cut the power to the system before making the connections.
Connect the phase wire to terminal
L
and the neutral to terminal
N
of
J7
(
38
).
Terminal board J7
PE
Earth
N
Neutral
L
Phase
Example: RP2
Summary of Contents for 746 E R Z20
Page 1: ...746 E R Z16 746 E R Z20 Translation of the original instructions...
Page 41: ...746 E R 41 732099 Rev D...
Page 42: ...746 E R 42 732099 Rev D...
Page 43: ......
