28
If using a low and high FLOAT SWITCHES:
Connect low float switch to input1 and high float switch to input2
Float switch must be normally open and closing when water is present.
Send:
Set user
Send:
Add user +xxxxxxxxxxxx
(this is the number of the sim card in the pump
controller SMS-2)
See page 8 of the manual (Adding a user)
Send:
Set +xxxxxxxxxxxx as pump
controller
(where xxxxxxx is the same
number as above)
Send:
Set float mode
To set-up the SMS-2 Connected To The Pump
SMS-2 (Pump controller)
Send the following commands:
Send: Set user
Send: Set pump mode
Send:
Add user +xxxxxxxxxxxx
(this is the number of the sim card in the tank
controller SMS-T4 )
See page 8 of the manual (Adding a user)
If you want to add more users, you can do so after the above
commands
Note: Connect the pump to output1
Finish
Once you are happy with the system you can stop the tank low / reset texts from the
tank controller and the Output auto On /Off texts from being sent to the users
Send to both the Tank and Pump Controller
Send:
Set pump text off
To re-instate
Send:
Set pump text on
Ezy Switch SMS-T4 Installation & Operation Manual
