For an E type glass set
- 12 -
Caution
Be sure to raise the jack before
setting glass parts.
First raise the jack before setting glass parts. If
the jack is raised during setting work, a personal
injury may result.
Caution
Take care for conditions and
handling of glass parts
Broken or flowed glass parts may result in accidents.
Inspect for damages or flows on glass parts and take
care when handling them.
Cooler
Capillary
feed tube
Coolant nozzle
（
gray
）
Vacuum nozzle (white)
Set screw
Housing
Rotary joint
Eyela clip
Specimen flask
Receiver flask
Ball joint clamp
Nozzle set
Nozzle packing
Screw plug
Cooler clamp
Cooler support bar
Support bar clamp
Cap screw
(1) Tentatively fix the cooler support bar in the hole of
the support bar clamp with the set screw. (Adjust the
position after setting a glass part.)
(2) Allow the adopter to tightly contact against the
vacuum seal in the housing and then tighten with the
cap screw.
When you have tighten to some extent, re-tighten both
the cap screw and the adopter at the same time and
position the receiver flask so that its fixing opening
faces downward.
(3) Install the cooler clamp.
Adjust the cooler support bar and the cooler positions
and fix with the set screw.
(4) Fix the receiver flask to the cooler with the ball
joint clamp.
(5) Fix the specimen flask to the rotary joint with the
Eyela clip.
(6) Gently insert the capillary into the adopter
(7) Install two coolant nozzles (gray), a vacuum nozzle
(white) and screw plug to the cooler.
Make sure that the nozzle packing sits in the groove
before installation.
(8) Follow the procedures above in the reversed order
to remove.
