- 14 –
LOCK
FREE
For S type
For V type
For E type
※
Connecting hose is not included.
Prepare a correct size after confirming the I.D.
of the connecting port.
※
Take care not to apply excessive force when
connecting. The connecting part is made of
glass and resin, which might break if
excessive force is applied.
(1) Connect the vacuum nozzle and the suction port of
your decompressing unit using a vacuum hose.
※
When connecting the vacuum hose, take care
not to intermix the suction port and the
exhaust port of the decompressing unit. If the
hose is connected in the wrong direction, the
unit will be compressed and cause a
malfunction.
(2) Connect the cooler coolant nozzle and the
circulation port of you coolant circulation unit
using a connecting hose through the hose holder.
※
Allow the coolant to circulated from the
outside of the corrugated tube.
8. Adjusting the angle of the drive body
Adjust the angle of the drive body
while holding the cooler with hand.
When you loosen the angle adjusting knob bolt, the
drive may suddenly incline from the weight of the
cooler or specimen and fall down and you might be
injured with broken glass.
Caution
(1) Lift the jack body.
(2) Loosen the angle adjusting knob bolt to adjust the
angle while supporting the cooler with a hand.
(3) Check the vertical position of the jack and its
position relative to the bath and then securely
tighten the angle adjusting knob bolt.
9-1. Connecting the vacuum hose and
the coolant hose
Vacuum nozzle
（
white
）
Coolant nozzle inlet
Coolant nozzle outlet
Vacuum nozzle
（
white
）
Coolant nozzle inlet
Coolant nozzle outlet
Vacuum nozzle
（
white
）
Coolant nozzle inlet
Coolant nozzle outlet
Angle
adjusting
knob bolt
