- 15 -
10. Installing the AC adaptor and
connecting the power supply cord
(1) Insert the power unit holder into the groove in the
back of the stand base pillar from above.
(2) Insert the AC adapter into the power unit holder and
insert the plug into the power jack at the back of the
control case.
※
There are two power jacks, any of which can be
used equally. The remaining one shall be
reserved for the set product “Vacuum control
unit model NVC-3000” and any other object
must not be inserted here to avoid an accident
or a malfunction.
※
AC adapter cables can be gathered by putting
them in the gap between the pillar and the
power unit holder. Make sure the connecting
plug will not be subject to excessive force by
checking the jack stroke. Making the cables
short forcibly will cause an accident or a
malfunction.
(3) Insert the power cord connector into the socket at
the bottom of the AC adapter.
(4) Insert the power plug to the outlet of the bus (Model
SB-1300
・
OSB-2200) or a power outlet.
AC adapter
Plug
Power jack
Connector
Power cord
Power plug
Power unit holder
You can connect/disconnect the hose using the
optional fingertip connecter.
9-2.Connecting the fingertip cooling
hose (optional)
Coolant nozzle
Fingertip connector
Fingertip connector (optional)
Relief sleeve
Fingertip cooling hose
（
optional
）
Fingertip hose nozzle
I.D. 10mm
（
optional
）
※
The connecting hose is not included.
Prepare a correct size after confirming the I.D.
of the connecting port.
※
Take care not to apply excessive force when
connecting. The connecting part is made of
glass and resin, which might break if
excessive force is applied.
(1) Install two standard coolant nozzles (gray) to the
fingertip connector.
Remove the coolant nozzle, make sure that the
internal packing for the fingertip connector has
been set and install to the cooler.
(2) Insert the fingertip cooling hose into the
inlet/outlet of coolant directly. Or insert the
fingertip hose nozzle to which the connecting hose
is installed.
(3) When removing the fingertip connector, pull out
the fingertip cooling hose or the fingertip hose
nozzle while pressing the relief sleeve with a
finger.
