E
on the previous page) — two speakers are located below the
screen, one on each side of the panel, and provide audible feedback for the user.
F
— detects motion between three to five feet from the touchpanel, and at
least 15° from the center axis.
•
When no motion has been detected for a user-defined period of time, the touchpanel
enters sleep mode.
•
When motion is detected by the sensor, the screen display is restored and active.
G
— activates the
(see page 8) and
page 13). Only the TLP Pro 1022M has a
Menu
button that can be accessed from the front
panel. The button is recessed in a hole below the front panel (see the arrow in
,
G
).
Use a screw driver with a fine blade to press the button.
Rear Panel Features
TLP Pro 1022M
TLP Pro 1022T
C
B
A
G
H
D
A
B
C
E
F
A
E
(TLP Pro 1022M only)
B
F
(TLP Pro 1022T only)
C
G
(TLP Pro 1022T only)
D
H
(TLP Pro 1022T only)
Figure 3.
TLP Pro 1022 Series Rear Panels
A
Reset LED
— indicates power status and reset status of the device (see
page 23).
B
Reset button
— initiates one of three reset modes for the unit (see
page 23).
C
Menu button
— activates the
(see page 8) and
page 13).
D
LAN/PoE Connector
— is on the back of the TLP Pro 1022M. On the TLP Pro 1022T, it is
in the top of the recessed area, to the right side.
NOTE:
These touchpanels are shipped without a power injector. The power injector
must be purchased separately.
ATTENTION:
•
The touchpanels are Power over Ethernet (PoE 802.3af, class 3) compliant. Do
not connect a power supply before reading the Attention notifications on
•
Les écrans tactiles sont compatible avec l’alimentation POE via Ethernet
(PoE 802.3af, classe 3). Ne branchez pas de sources d’alimentation externes
avant d’avoir lu les mises en garde sur
.
TLP Pro 1022 Series • Panel Features
5
Summary of Contents for TLP Pro 1022T
Page 6: ......
