Mounting without a wall box
If the wall box is not required by local building codes, you can mount the touchpanel directly into
drywall.
1.
Download the cut-out template for your touchpanel from
. Print it at 100%
(no scaling).
2.
Use the template to mark the wall, cut the hole, and drill the four pilot holes.
The size of the cut-out hole is 7.68 inches (19.51 cm) wide x 5.93 inches (15.06 cm) high.
NOTE:
You can also use the mounting plate as a template to mark where the hole
should be cut out and the pilot holes should be drilled.
3.
Fasten the mounting plate and complete the installation, as described in
previous page.
Furniture Mounting
The TLP Pro 1022M can be mounted into the surface of a lectern or other furniture by following
the same procedure as wall
, above.
1.
Download the cut-out template for your touchpanel from
. Print it at 100%
(no scaling).
2.
Use the template to mark the furniture surface, cut the hole, and drill the four pilot holes.
The size of the cut-out hole is 7.68 inches (19.51 cm) wide x 5.93 inches (15.06 cm) high.
ATTENTION:
•
All structural steps and electrical installation must be performed by qualified
personnel in accordance with local and national building codes and electrical
codes.
•
Toute étape structurelle et installation électrique, doit être effectuée par un
personnel qualifié, conformément aux codes du bâtiment, aux codes incendie et
sécurité, et aux codes électriques, locaux et nationaux.
NOTE:
You can also use the mounting plate as a template to mark where the hole
should be cut out and the pilot holes should be drilled.
3.
Fasten the mounting plate and complete the installation, as described in
previous page.
TLP Pro 1022 Series • Mounting
20
Summary of Contents for TLP Pro 1022T
Page 6: ......
