Reference
Material
This section describes:
•
Network Port Requirements and Licensed Third-Party Software Used by the
Touchpanels
•
Network Port Requirements and Licensed Third-Party Software Used
by the Touchpanels
For information about network port requirements and licensed third-party software for the
TLP Pro 1022 series touchpanels, please refer to the
Pro Series Control Product Network Ports
and Licenses Guide
.
Reset Modes
The TLP Pro 1022 Series touchpanels have three reset modes that are initiated by pressing the
Reset button:
•
•
•
The Reset button is found on the rear panel (see
B
, on page 5).
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle
in the event of a firmware update that failed or incompatibility issues arising with user-loaded
firmware
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1.
On the touchpanel, hold down the recessed
Reset
button while applying power to the
unit. When power is restored, the Reset LED lights. Hold the
Reset
button for a further two
seconds before releasing it. The touchpanel enters factory firmware mode.
2.
Upload new firmware to the unit as desired (see
NOTE:
Do not continue to operate the touchpanel using the factory firmware version. If
you want to use the factory default firmware, you must upload that version again (see
on page 17).
TLP Pro 1022 Series • Reference Material
23
Summary of Contents for TLP Pro 1022T
Page 6: ......