SMX System MultiMatrix Switchers
• Pr
ogrammer's Guide
Pr
ogrammer's Guide, cont’d
4-12
Also refer to the
SMX System MultiMatrix Switchers User’
s Manual
at www
.extron.com.
Command
ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
IP setup commands cont'd
Set verbose mode
E
X3&
CV
}
Vrb
X3&]
Enable or disable verbose mode and/or
tagged responses, in which additional
information is given in query response.
N
The SMX can send out unsolicited information (such as a notice of a change in input or some other setting). This a verbose (wordy)
relationship between the switcher and a connected device. For a direct RS-232/422 connection, the SMX is set for verbose mode by default.
When the SMX is connected via Ethernet, verbose mode is disabled by default in order to reduce the amount of communication traffic on the
network. To use verbose mode with a switcher connected via Ethernet, you must set this mode to on each time you reconnect to the SMX.
View verbose mode
E
CV
}
X3&
]
Reset commands
Reset all device settings
to factory settings
E
ZXXX
}
Zpx
]
Clears all ties and presets, audio gain and
volume, and resets unit to factory default.
N
Excludes IP settings, e.g., IP address, subnet mask, and gateway address. Does not remove file system.
Absolute system reset
E
ZQQQ
}
Zpq
]
Clears all ties and presets, and resets unit
to factory default (mode 5 reset).
N
Includes resetting IP address to 192.168.254.254 and subnet mask to 255.255.0.0. Firmware version remains same.
N
X3&
= Verbose mode: 0 = neither verbose mode nor tagged responses enabled; 1 = verbose enabled, no tagged responses (default);
2 = tagged responses enabled, verbose mode disabled; 3 = verbose mode and tagged responses enabled
