Extron electronics HC 404, User Manual

Page: 30 / 73

HC 404 System • Hardware Features and Installation 22
Network Communication Setup
Network setup is essential before you configure control settings. You can configure basic
network settings in one of the following ways:
• Via front panel controls and the OSD menu — a quick method to use whether or
not you need to configure other settings. This requires connection to a display device.
• Via PCS software — a method that provides basic network configuration and is
convenient when you are ready to use PCS to configure AV settings. This requires a PC,
software, and a LAN or USB connection.
• Via Toolbelt software — a method that allows you to configure additional connection
settings and is convenient when you want to configure additional device, password,
system, and control port settings. This requires a PC, software, and a LAN connection.
Network Configuration via OSD Menu
To configure network settings from the OSD menu:
1. Connect an HDMI display device to the HDMI/CEC output connector on the HCR 102.
2.
Power on the receiver and the display device, if they are not already powered on.
3. On the front panel of the receiver, press the Menu button. The on-screen display should
appear on the connected display or in the projected image.
4. Press the front panel Menu button on the HCR 102 (see figure 2 , F for button
location). The OSD main menu appears on the display.
NOTE:
For details on the OSD menu system and its use, see Using the OSD
Menu System starting on page 28.
5. Navigate through the menus and make adjustments. For the IP address, either set a
static IP address (with DHCP off) or turn DHCP on to let the DHCP server select the IP
address for the unit.
a. Press the up  and down  arrow navigation buttons (see figure 2 ,
H
) to
navigate to and highlight the desired menu or submenu. For network configuration,
select the
Quick Setup menu or the Communication menu.
b. Press the
Enter
button (see G ) or
right 
arrow button to access submenu
items for the selected submenu.
c. Press the up

and down

arrow buttons to navigate to and highlight submenu
items.
d. Press the Enter or right

arrow button to adjust a submenu item.
From the Quick Setup menu:
•
DHCP — Select and enter the DHCP Mode submenu and press the arrow buttons
to turn DHCP on or off (default: off).
•
IP address — Select and enter the IP Address submenu. Press the left 
or right  arrow button to move between octets. Press the up  and down 
arrow buttons to change the value in the selected octet.
Default: 192.168.254.250.
From the Communication menu:
NOTE: Hold the Enter button for 10 seconds to make changes in this submenu.
•
DHCP — Select and enter the DHCP Mode submenu and press the arrow buttons
to turn DHCP on or off (default: off).