Extron electronics FOX3 Matrix 160x, User Manual

Page: 20 / 61

Power Supply Modules
F
Power supplies (see figure 2 on page 8) — The Primary and Redundant power
supplies are hot-swappable (see Removing and Installing a Power Supply Module
on page 51 to replace power supplies).
There are two corresponding LEDs on the front panel that indicate the status of each
power supply (see
Front Panel Features on page 13).
G
Power connectors — Plug standard IEC power cords into these connectors to
connect the switcher to 100 VAC to 240 VAC, 50 or 60 Hz power sources.
NOTE: For the most reliable power, connect the power cord from the Redundant
power connector to either an uninterruptible power source or a power source
completely independent from the primary power source.
Audio Connections
H
Audio Inputs
— Connect audio input devices to an audio 5-pole captive screw port
(see figure 6 to wire the captive screw connector).
Unbalanced Stereo Input Balanced Stereo Input
Do not tin the wires!
Tip
Ring
Tip
Ring
LR
Sleeves
Tip
Sleeve
Sleeve
Tip
LR
Figure 6. Audio Input Wiring
I
Audio Outputs — Connect audio output devices to an audio 5-pole captive screw port
(see figure 7 to wire the captive screw connector).
Unbalanced Stereo Output Balanced Stereo Output
Do not tin the wires!
Tip
No Ground Here
No Ground Here
Tip
LR
Sleeves
Tip
Ring
Tip
Ring
LR
Sleeves
Figure 7. Audio Output Wiring
ATTENTION:
• For unbalanced audio, connect the sleeves to the ground contact. DO NOT
connect the sleeves to the negative (-) contacts.
• Pour l’audio asymétrique, connectez les manchons au contact au sol. Ne PAS
connecter les manchons aux contacts négatifs (–).
J
DMP Expansion port and LED — (see figure 2 on page 8)
• Expansion Port — Connect an STP cable between this port and the Expansion
port on an optional Extron DMP Digital Matrix Processor for digital audio
connection. Receive and transmit eight 2-channel stereo inputs and eight 2-channel
stereo outputs via this RJ-45 connection.
NOTE: Only connect non-AT audio devices to the DMP Expansion port.
• Link LED — Lights to indicate that the port is connected to a compatible device.
K
Dante AT Expansion ports — Connect RJ-45 connectors to external Dante devices
for digital audio networking. Receive and transmit 32 2-channel inputs and 32
2-channel outputs via these two RJ-45 connections.
The FOX3 Matrix uses Dante Controller for Windows from Audinate to select and route
inputs and outputs for all connected Extron FOX3 transmitters and receivers and other
Dante-compatible audio devices.
Download and install the latest version of Dante Controller for Windows from the Dante
Controller product page (see
Software/Firmware Installation on page 30).
6
7
FOX3 Matrix Series Switchers • Installation 12