FOX II T HD 4K Transmitter • Installation and Operation
9
3.
Place the LockIt Lacing Bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket (see
).
ATTENTION:
•
Do not overtighten the HDMI connector mounting screw. The shield it fastens
to is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt Lacing
Bracket as shown (
).
5.
While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length (
RS-232 and IR connections
Figure 4 shows how to wire the RS-232 and IR connectors.
Tx Rx
Rx Tx
Gnd
Gnd
IR Device
RS-232 Device
RS-232 Device
RS-232
ALARM
Tx
Rx
G
12
REMOTE
RS-232
IR
Tx
Rx
Tx
Rx
G
OVER
FIBER
Gnd
Tx Rx
Figure 4.
RS-232 and IR Connector Wiring
NOTES:
•
The length of exposed wires is important.
The ideal length is 3/16 inch (5 mm)
.
•
Longer bare wires can short together.
•
Shorter wires are not as secure in the connectors and could be pulled out.
•
Do not tin the power supply leads before installing them in the connector. Tinned
wires are not as secure in the connector and could be pulled out.
Audio connections
NOTE:
The level of the analog audio inputs can be set via an
(see page 18) or using the Product Configuration Software
The following table shows the audio format that is sent over the fiber connection, along with
the HDMI video, when the audio input format is set to
Auto
(the default setting, see the
Input audio selection
on page 18 to switch the active audio source).
Embedded HDMI
Audio
Analog Audio
Transmitted Audio
Present
Not present
Embedded audio
Present
Present
Embedded audio
Not present
Present
Analog audio
Not present
Not present
No audio
Summary of Contents for FOX II T HD 4K
Page 6: ......
