FOX II T HD 4K Transmitter • Installation and Operation
7
(see figure 2 on page 5)—
WARNING:
The FOX II T HD 4K outputs continuous invisible light (Class 1 rated),
which may be harmful to the eyes; use with caution. Plug the attached dust cap
into the optical transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT :
Le FOX II T HD 4K émet une lumière invisible en continu
(conforme à la classe 1) qui peut être dangereux pour les yeux, à utiliser avec
précaution Branchez la protection contre la poussière dans l’ensemble
émetteur/récepteur lorsque le câble fibre optique est débranché.
NOTES:
•
Ensure that you use the proper fiber cable for your transmitter. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange or
aqua jacket.
•
Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for video,
audio, and RS-232 and IR signal transmission.
But
, if you connect only one
fiber optic cable:
•
The digital video signal output by the receiver
is not
HDCP-compliant.
•
You
will not
receive RS-232 reports or return audio from the controlled
device.
•
To receive responses from the controlled device and for HDCP compliance,
you must install both fiber optic cables.
1
Tx (required)
— For all one-way video, audio, and serial
Transmitter
to
Receiver
OPTICAL
Tx
LINK
LINK
Rx
OPTICAL
Tx
LINK
LINK
Rx
1
1
2
2
communications from the transmitter to the receiver, connect a
fiber optic cable to the Tx LC connector.
Connect the opposite end of this fiber optic cable to the Rx LC
connector on a FOX II R DP 4K receiver or to any other compatible
Extron FOX II device.
2
Rx (optional)
— For one-way return audio and serial
communications from the receiver to the transmitter, connect a
fiber optic cable to the Rx LC connector.
Connect the opposite end of this fiber optic cable to the Tx LC
connector on a FOX II R DP 4K receiver or to any other compatible
Extron FOX II device.
Tx Link and Rx Link LEDs
— When lit, the link is active (light is
sensed).
— Plug a standard IEC power cord into this connector to connect the
transmitter to a 100 VAC to 240 VAC, 50-60 Hz power source. The lit LED indicates
power is applied.
Summary of Contents for FOX II T HD 4K
Page 6: ......
