DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation
8
C
TP connector
— Plug one end of a STP cable to this RJ-45 female jack
LINK SIG
OUT
on the switching transmitter. Plug the opposite end of this cable into the
DTP Input RJ-45 connector on a compatible receiver (see
TP Cable
Termination and Recommendations
on page 13 to properly wire the
RJ-45 connector and for detailed
NOTES
).
Signal LED indicator
— Lights green when the transmitter outputs a video signal or a
test pattern.
Link LED indicator
— Lights yellow when a device is connected and communication
is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
D
Over TP RS-232 and IR port
— Plug a serial RS-232 signal, a
Tx Rx G Tx Rx
RS-232
OVER TP
IR
modulated IR signal (up to 40 kHz), or both into this 3.5 mm, 5-pole direct
insertion connector for bidirectional RS-232 and IR communication (see
IR
and RS-232 Connector Wiring
on page 14
to wire the connector).
RS-232 and IR data can be transmitted simultaneously.
E
Remote RS-232 port
— Plug a host device into the switching transmitter via
Tx Rx G
RS-232
REMOTE
the 3.5 mm, 3-pole direct insertion connector for remote control of the
transmitter (see
IR and RS-232 Connector Wiring
on page 14
to wire the
connector).
•
9600 Baud
•
8 data bits
•
No parity
•
1 stop bit
F
Power connector
— Plug the included external 12 VDC power supply into
1.0 A MA
POWER
12V
either this 2-pole direct insertion connector (see
Power Supply Wiring
on page
15 to wire the connector).
Or
, power the receiver (see the
DTP HDMI 330 User
Guide
or
DTP HDMI 230 User Guide
, available at
www.extron.com
) and leave
the TP function switch in DTP position.
NOTE:
When the TP function switch
(
item
A
on page 7)
is in the DTP
position
, one power supply can power both units.
When the TP function switch is in the HDBT position
, the transmitter
and receiver each requires a local 12 VDC power supply.
G
Reset button
— The Reset button initiates a reset of the switcher (see
RESET
Reset
on page 17 for details).
