DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation
7
Rear Panel and Side Panel Features
Top
Side
Rear
DTP
HDBT
RESET
CONFIG
1.0 A MAX
SI
GL
INK
OUT
Tx Rx G
Tx Rx G
Tx Rx
RS-232
OVER TP
RS-232
POWER
12V
IR
REMOTE
B
A
C
G
F
E
D
Figure 3.
Rear Panel and Side Panel Features
A
TP function switch
(see below)
E
Remote RS-232 port
(see
page 8
)
B
Configuration port
(see below)
F
Power connector
(see
page 8
)
C
TP connector
(see
page 8
)
G
Reset button
(see
page 8
)
D
Over TP RS-232 and IR port port
(see
page 8
)
A
TP function switch
— If the receiving device is in the Extron DTP series, set this
HDTP
DTP
switch to the DTP position. For an HDBaseT-enabled receiver type, set this switch
to the HDBT position. This switch tailors the output signal as follows:
ATTENTION
:
•
Position this switch
BEFORE
connecting the appropriate device to the TP
connector. Failure to comply can damage the endpoint.
•
Positionnez le sélecteur
AVANT
de connecter l’appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager le
point de connexion.
HDBT position
— The TP output consists of HDMI with embedded audio plus RS-232
and IR.
DTP position
— TP output consists of HDMI with embedded audio, analog audio,
RS-232 and IR, and remote power.
NOTES:
•
When the switch is in the HDBT position
, the transmitter and receiver each
requires a local 12 VDC power supply.
•
When the switch is in the DTP position
, one 12 VDC power supply,
connected to either the transmitter or the receiver, can power both units.
B
Config port
— Connect a host device to the USB mini B configuration port.
CONFIG
NOTE:
A Configuration port connection and a Remote RS-232 port connection can
both be active at the same time. If commands are sent simultaneously to both, the
command that reaches the processor first is handled first.
